Operating Procedure

(2) Fully turn the adjusting knob clockwise and make sure that the needle of the meter [3] is at extreme right-hand side (blue zone).

(3) Insert a sheet of paper to be run between the light emitting and receiving elements as shown in the Fig. 2.


(5) Insert another sheet of paper between the emitting ang receiving elements and check to see needle of the meter [3] moves to the left side (red zone) as shown in the Fig. 4.

*Note :
PlacetheTHIN THICKselector switch [6] in the THIN or THICK position according to the thickness of paper to be used.
(6) Place the selector switch [5] in the CONT. Side ang push the CHECK push button [7]. Then the timing light [8] flicker at a time. If two sheets of paper are inserted between the light emitting and receiving elements, the ALARM light [9] illuminates at the same time.
When the selector switch [5] is in the CONT. Position and CHECK push button [7] is pushed, with two sheets of paper placed between the emitting and receiving elements, the timing light [8] flickers at a time and the ALARM light illuminates simultaneously.
This is how the machine stops when two sheets of paper are detected. If the CHECK push button [7] is pushed with a sheet of paper placed, are timing light [8] flickers and the ALARM light does not illuminate. The machine goes on working as it is.
*Note :
1.The machine does not work when the selector switch [5] is on the METER side.
2.Turn the ON-OFF switch [1] OFF when suffering losses in printing or binding

http://www.forumesinpercetakan.com/2013/07/double-sheet-detector-oliver-52-8-58-12.html
No comments:
Post a Comment
Note: only a member of this blog may post a comment.